home *** CD-ROM | disk | FTP | other *** search
-
- An RF (Radio Frequency) Sniffer from 1MHz to 1GHz.
- --------------------------------------------------
-
-
- Minimum operating requirements are:-
- ------------------------------------
-
- 1) Standard Amiga A500 with 512Kb or more of memory.
- 2) Workbench 1.3x.
- 3) An external floppy disk drive is required.
- 4) OCS.
- 5) The mouse is optional.
- 6) The software has NOT been tested on an Amiga A1000.
- 7) The software has NOT been tested on Workbench 1.2x or less.
- 8) The software has NOT been tested on Workbench 3.1x or greater.
-
- ----------------------------------------------------------------------------
-
- General information:-
- ---------------------
-
- An RF (Radio Frequency) Probe (Sniffer) used to set up all types of
- RF stages in transmitters. It is purely a detector and uses the Analogue
- to Digital Converter as a level meter only. It does not need to be
- calibrated.
-
- This software was written using ACE basic compiler and some assembler.
-
- ----------------------------------------------------------------------------
-
- Now the legal stuff:-
- ---------------------
-
- This program is the copyright of (C)2000 Barry Walker with all
- rights reserved.
- It is freeware and no profit will be made from it, also the files
- must remain unaltered.
- The author is not responsible for any damage to, or loss of, or
- failure of equipment or data caused in any way by the use of this
- program.
-
- ----------------------------------------------------------------------------
-
- Testing evaluation:-
- --------------------
-
- This was tested on an A500 with various memory configurations,
- the same A500 switched to 1MB Chip Ram and emulating WB2 using
- the A500+ emulator, an A600 with various memory configurations,
- the same A600 emulating WB3 with various memory configurations,
- an A1200 with various memory configurations, and a similar A1200
- with a Turbo LC accelerator board and an '030 with 34MB of ram
- thanks to Laurence J Greatorex, and also to Bob Eva for testing
- on his A1200, with a total of 10MB of ram.
-
- ----------------------------------------------------------------------------
-
- Look for the ~TestGear3.lha~ and ~TestGear3.readme~ on Aminet.
-
- ----------------------------------------------------------------------------
-
- Bug Reports:-
- -------------
- All bug reports should be sent in plain text to my Compuserve Email
- address i.e. 106161.3245@compuserve.com and I will endeavour
- to cure them.
-
-
- Contact:-
- ---------
-
- Mr Barry Walker,
- 70 King George Road,
- Loughborough,
- Leicestershire,
- LE11 2PA,
- England.
-
- Email to:-
-
- 106161.3245@compuserve.com
- or
- wisecracker@tesco.net
-
- BYE.....
-
- ----------------------------------------------------------------------------
-